http://wiki.ferrari.mo.it/index.php?action=history&feed=atom&title=NanoPC_T2 2026-04-09T12:06:13Z Revision history for this page on the wiki MediaWiki 1.34.1 http://wiki.ferrari.mo.it/index.php?title=NanoPC_T2&diff=301&oldid=prev 2022-08-19T13:14:17Z

<p>Created page with &quot;= Installation = Both s5p4418-eflasher-friendlycore-xenial-4.4-armhf-20211123.img and s5p4418-eflasher-friendlycore-lite-focal-4.4-armhf-20211123.img are good. Flash o...&quot;</p> <p><b>New page</b></p><div>= Installation =<br /> <br /> Both<br /> <br /> s5p4418-eflasher-friendlycore-xenial-4.4-armhf-20211123.img<br /> <br /> and<br /> <br /> s5p4418-eflasher-friendlycore-lite-focal-4.4-armhf-20211123.img<br /> <br /> are good.<br /> <br /> Flash one of them on a 16GB SD card with Balena Etcher.<br /> <br /> Then, insert the SD on the NanoPC-T2 slot. Press the BOOT SEL (not the Reset, refer to https://wiki.friendlyelec.com/wiki/index.php/NanoPC-T2 ) while switching on the board.<br /> <br /> If you have a keyboard, mouse and monitor, select the only operating system available, with the &#039;start at boot&#039; and &#039;low format&#039; options.<br /> <br /> Wait and switch the board off. Then remove the card and start the board.<br /> <br /> Debug is available with the COM debug port (ttyAMA0 on the board, go to the Windows device management to find the right COM). Parameters are 115200 baud, 8 data bits, 1 stop bits, parity none and flow control XON/XOFF.<br /> <br /> The RDM9600 WORKS on ttyAMA2, ttyAMA3 and ttyAMA4.</div>

62.173.173.193