Preparing NanoPI M1 Plus
Jump to navigation
Jump to search
Preparing NanoPI M1 Plus for Eywa
Step 1 - Flash card
Download nanopi-m1-plus_sd_debian-jessie_4.14_armhf_20181119.img from FriendlyElec shared folder.
Then, flash an SD card (we used Toshiba 16Gb) with balena Etcher (or equivalent).
The username/password of the system is root / fa .
Step 2 - Remove the unwanted packages
apt-get --yes --force-yes remove --auto-remove --purge network-manager x11-common x11-proto*
Before rebooting the system, you must configure /etc/network/interfaces with the following:
auto lo iface lo inet loopback auto eth0 iface eth0 inet static address 10.10.10.17 netmask 255.255.255.0 gateway 10.10.10.254
NOTE: the eth0 is unconfigured by default. If you forget to configure it in the file and reboot, the board will be inaccessible by ssh.
