Difference between revisions of "RDM6300"

Revision as of 17:55, 14 November 2021

RDM6300 can be powered from NanoPI +5V pin. However, it does not require voltage adapters for signals, as the signals are 3.3V (in and out).

You can connect pins 4 (VCC 5V), 6 (GND), 8 (UART1 TX) and 10 (UART1 RX) to the corresponding pins in the board (of course, TX to RX and vice versa).

Check, using npi-config, that UART1 is enabled (npi-config -> Advanced options -> Serial -> serial1).

Download and compile comtest

git clone https://github.com/friendlyarm/comtest.git
cd comtest
gcc -o comtest comtest.c

then test it

./comtest -d /dev/ttyS1 -s 9600

If you put an RFID near to the antenna, you should see its ID repeated on the console until it's near the antenna (about 1cm).

Configurarion (it can be tested with putty on Windows with an USB debug device with 5V power supply enabled):

Baud 9600
Data 8
Stop 1
Parity none
Flow controlo XON/XOFF

@@ Line 23: / Line 23: @@
 If you put an RFID near to the antenna, you should see its ID repeated on the console until it's near the antenna (about 1cm).
-Configurarion (it can be tested with an USB debug device with 5V power supply enabled):
+Configurarion (it can be tested with putty on Windows with an USB debug device with 5V power supply enabled):
   Baud 9600