Difference between revisions of "Preparing NanoPI M1 Plus"

Revision as of 15:44, 19 April 2019

Download nanopi-m1-plus_sd_debian-jessie_4.14_armhf_20181119.img from FriendlyElec shared folder.

Then, flash an SD card (we used Toshiba 16Gb) with balena Etcher (or equivalent).

The username/password of the system is root / fa .

apt-get --yes --force-yes remove --auto-remove --purge network-manager x11-common x11-proto*

Before rebooting the system, you must configure /etc/network/interfaces with the following:

auto lo
iface lo inet loopback

auto eth0
iface eth0 inet static
address 10.10.10.17
netmask 255.255.255.0
gateway 10.10.10.254

NOTE: the eth0 is unconfigured by default. If you forget to configure it in the file and reboot, the board will be inaccessible by ssh.

Then, remove the unwanted directories:

sudo apt-get install curl software-properties-common
curl -sL https://deb.nodesource.com/setup_10.x | sudo bash -

apt-get install nodejs

Copy the eywa directory to

@@ Line 25: / Line 25: @@
 NOTE: the eth0 is unconfigured by default. If you forget to configure it in the file and reboot, the board will be inaccessible by ssh.
+Then, remove the unwanted directories:
+=== Step 3 - Install node ===
+ sudo apt-get install curl software-properties-common
+ curl -sL https://deb.nodesource.com/setup_10.x | sudo bash -
+ apt-get install nodejs
+=== Step 4 - Install Eywa and its packages ===
+Copy the eywa directory to