Difference between revisions of "RDM6300"
Jump to navigation
Jump to search
(→Test) |
(→Test) |
||
| Line 6: | Line 6: | ||
You can connect pins 4 (VCC 5V), 6 (GND), 8 (UART1 TX) and 10 (UART1 RX) to the corresponding pins in the board (of course, TX to RX and vice versa). | You can connect pins 4 (VCC 5V), 6 (GND), 8 (UART1 TX) and 10 (UART1 RX) to the corresponding pins in the board (of course, TX to RX and vice versa). | ||
| + | |||
| + | [[File:RFID125Headers.png]] | ||
Revision as of 19:53, 20 April 2020
Pins and voltage
RDM6300 can be powered from NanoPI +5V pin. However, it does not require voltage adapters for signals, as the signals are 3.3V (in and out).
Test
You can connect pins 4 (VCC 5V), 6 (GND), 8 (UART1 TX) and 10 (UART1 RX) to the corresponding pins in the board (of course, TX to RX and vice versa).
